United States · Oklahoma

South 75 Motocross Park

Data origin7 entries from an importCheck date not documented

Create setup for this track →Start route →

Location

Track details

MotocrossClay

Soil when dry

Dry clay rides almost like concrete: hard, polished, little mechanical grip.

Soil after rain

Wet clay is extremely slippery and packs into the knobs - gentle throttle, clean lines.

Oklahoma, United States35.74000, -96.07000

Track condition today

Good30 °C4 % rain9 km/h

Clay at 30 °C, no rain right now - good conditions to ride.

Low confidence · Based on: Weather model

The soil is drying out and getting dusty. Grip on the hard top layer is limited - trending dry, slick and dusty. Very warm: mind cooling, hydration and tire pressure.

Next windowtoday 10:00–20:00

Recommendation

Check tire pressure, keep rebound from being too slow, watch traction on corner exit.
Adapt pressure or mousse to the heat, plan more breaks.

Reports from the track

Anyone riding there today can report how the ground is running in 30 seconds. Those reports decide the assessment above - without them it stays a weather forecast.

No report has been filed for this track yet, so the assessment above rests on the weather model alone.

Takes under 30 seconds.

What to expect

Biggest challenge: Front knifes/oversteers in ruts Go to diagnosis →
Typical setup problem: The fork rides too low (too soft) and knifes into the rut - add compression.
Riding-technique focus: Vision and line in ruts Go to the technique guide →

Automatically derived: this track's attributes combined with LAISA's troubleshooting knowledge.

Organisation and rules

LAISA has nothing confirmed about opening hours, fees or rules for this track. Please check with the operator before travelling.

Short answer for this track

Recommended starting point: Clay - Motocross - start from the setup computed for your bike. Compute a setup →
Most important change: For this track the LAISA engine mainly moves: Shock: Rebound, Fork: Compression, Shock: Compression. The actual values depend on your bike and your rider profile.
Why: Surface Clay.
How to test it: Ride two laps on the starting value, then change one setting only and ride the same two laps again.
Source: 7 entries from an import

No shared setups and no rating for this track yet. Share yours and help riders prepare.Setup for this track →