Canada · Nova Scotia

Mill Hill MX

Data origin8 entries from an importCheck date not documented

Create setup for this track →Start route →

Location

Track details

MotocrossLoamTechnicalJumps

Soil when dry

Dry loam is the ideal case: grippy, forms lines and forgives mistakes.

Soil after rain

After rain loam turns heavy and sticky - knobs pack up and the bike feels noticeably heavier.

Setup tendencyMore agileHarder against bottoming

Nova Scotia, Canada45.16200, -64.41700

Track condition today

Limited18 °C53 % rain20 km/h

Loam at 18 °C with rain or a high rain probability - expect a wet, slippery surface.

Low confidence · Based on: Weather model

Expect mud and packed-up knobs.

Next windowtoday 14:00–14:00

Recommendation

Pick an open/mud-sand tread, drop tire pressure slightly.

Reports from the track

Anyone riding there today can report how the ground is running in 30 seconds. Those reports decide the assessment above - without them it stays a weather forecast.

No report has been filed for this track yet, so the assessment above rests on the weather model alone.

Takes under 30 seconds.

Track profile

Difficulty: Demanding

Technical5/5
Jumps5/5
Fitness5/5

Not rated: Speed, Grip changes

Automatically derived from the recorded track characteristics - not assessed by LAISA on site.

What to expect

Biggest challenge: Bike kicks / bucks off jump faces Go to diagnosis →
Typical setup problem: Rebound returns too fast and launches the rear off the face - slow it (fewer clicks out).
Riding-technique focus: Controlling the bike off jump faces Go to the technique guide →

Automatically derived: this track's attributes combined with LAISA's troubleshooting knowledge.

Organisation and rules

LAISA has nothing confirmed about opening hours, fees or rules for this track. Please check with the operator before travelling.

Short answer for this track

Recommended starting point: Loam - Motocross - start from the setup computed for your bike. Compute a setup →
Most important change: For this track the LAISA engine mainly moves: Fork: Compression, Shock: Compression, Fork: Rebound. The actual values depend on your bike and your rider profile.
Why: Surface Loam, track character: Technical, Jumps.
How to test it: Ride two laps on the starting value, then change one setting only and ride the same two laps again.
Source: 8 entries from an import

No shared setups and no rating for this track yet. Share yours and help riders prepare.Setup for this track →